Made-to-order metal artwork and home decor for indoor and outdoor use. We also offer premium hardware to hang your artwork!
Shop Metal Creations
We’re excited to offer wholesale orders for many of our products. Reach out to learn more!
Interested in Wholesale?
Hanging Hardware for Metal Art
This hanging system uses countersunk neodymium magnets to mount metal artwork without visible hardware, creating a clean floating appearance when installed correctly.
12-16 inch pieces: 2 magnets
Larger pieces: 4 or more magnets
These countersunk Neodymium magnets are screwed to the wall and used as the method for hanging metal art pieces that don’t have screw holes in them, leaving a floating appearance of the art with no hardware showing if done properly.
Each pack includes 4-8 countersunk magnets, screws, sheetrock anchors and instructions.
For 12-16" pieces 2 magnets are required, for larger pieces 4+ is recommended.
Instructions:
Screw countersunk magnet(s) into wall where you are going to hang your piece, using included sheetrock anchors if necessary.
Be careful not to tighten down too tight, magnets are very fragile and WILL crack apart. Using a hand screw driver to tighten down is recommended.
Place art directly on magnet(s) to where it is balanced and showing little to none.
This may require measuring before hanging magnets.
Warning: Magnets included are Neodymium Rare-Earth Magnets that are VERY strong. They can hold UP TO 10lbs of pressure each. Be careful in handling your magnets as they can slam together quickly and unexpectedly.
Installation Instructions
Neodymium rare-earth magnets are extremely strong and can hold up to 10 pounds each. Handle with care, as magnets can snap together quickly and unexpectedly.
Screw the countersunk magnet into the wall where the artwork will hang, using the included sheetrock anchors if needed.
Tighten carefully. Neodymium magnets are fragile and can crack if overtightened. A hand screwdriver is recommended.
Place the artwork onto the mounted magnet or magnets and adjust until balanced and level.
Measuring placement before installation may help achieve the best result
Let’s get to work
Have an idea, a sketch, or a specific need in mind?
We are ready to turn it into a work of metal art
